J-6 Water-Based Epoxy Floor Paint

Product information:
J-6 water-based epoxy floor paint is a two-liquid water-based epoxy resin coating, which is convenient to use, easy to prepare, and dries quickly. The product can be applied to various floor materials and surfaces. This product can also be used with J-4 primer. After drying, the product forms friction-resistant layer with anti-slip effect. Can be used indoors. The product is easy to maintain, easy to repair, and has prolonged service life. Damaged floor areas can be easily repaired without the need to remove the product from the entire floor surface, helping to save costs. This economical and multi-purpose floor treatment comes in various colors and can be customized.

Applicable scope:
Factories, kitchens, shopping malls, parking lots, and other surfaces.

Applicable surfaces:
Ceramic tiles, stone, terrazzo floors, glass fiber reinforced plastic, metal, glass, wood, cement floors, PVC floor tiles, and epoxy resin floors.

Instructions for use:
1. Applying tools: Roller brush, paint tray, electric mixer, paper tape, gloves.
2. Ensure the surface on which the product will be applied is clean, oil-free, dust-free, and dry to ensure best results.
3. How to use J-6 water-based epoxy floor paint: Pour Agent A and Agent B into a mixing bucket at a ratio of 1:1. Stir the product well to mix (if solution is too thick, add a water). It is recommended to use an electric mixer. When applying, use a roller to apply (two coats are required). Wait between coats for the surface to dry (about 1-4 hours depending on conditions; touch the surface it with your hand to check if it's dry).
4. General floor: Apply it to the floor with a roller and wait between coats for the surface to dry (about one hour) before applying the second coat.
5. General floor (when primer is needed): Apply J-4 primer to the floor (one coat is sufficient), and wait for the surface to dry (about 30 minutes). Then apply J-6 water-based epoxy floor paint (two coats are required). Apply to the floor with a roller, and wait between coats for the surface to dry (about one hour).
6. Anti-slip floor: Apply J-4 primer to the floor (two coats are required), and wait for the surface to dry between coats (about 30 minutes). Then apply J-6 water-based epoxy floor paint (two coats are required). Use a roller to apply it to the floor, and wait for the surface to dry (about one hour). 　

Attention:
Suggestions for the mixing ratio (if water is needed to dilute the solution, Agent A and Agent B should be mixed before adding water).